|
The SX210 timer is a
microprocessor based digital timer housed in a standard DIN style case
(68mm square cutout). The small case and front bezel require minimal
panel space yet provide large, easy to use programming keys and a .3
inch high LED display.
Eight programmable time ranges and eight output operating modes
Operating modes and all other setup functions programmed with miniature
rocker switches located on the back of the housing
Nonvolatile RAM memory retains setpoint, actual time values, and program
parameters (10 year expected life of data in memory)
NEMA 4 Hosedown Test rated
Special surface just below the display on which the function can be
marked with pen or pencil
SET and ENT keys provide access to setpoint and front panel programmed
functions
Programming changes entered via increment and decrement keys
Keypad "lock" function allows setpoint to be viewed, but does
not allow unauthorized changes
Four .3 inch red LED displays for easy readability
Flashing LED (right side of display) indicates unit is in timing cycle
and LED (left side of display) lights when programmed contacts are
energized
Two removable terminal blocks with screw gate style wire clamps permit
prewiring of panel without the timer in place and eliminate rewiring if
unit needs to be removed or replaced
Two DPDT relay outputs with five amp contact ratings - one is a set of
instantaneous contacts that energize when timing cycle starts and remain
energized until timer is reset, and the other is a set of programmable
contacts that can be programmed to turn on and off in several operating
modes
Buy
These Online At www.industrialcontrolonline.com
Download
The Specification Sheet
|
